Dukane Infinity Series - Testing the Ultrasonic Stack; Running a Weld Cycle; Viewing Weld Results and Data

403-618-03 Infinity™ Series Servo Ultrasonic Press Systems User Manual
77
SECTION 6 | OPERATION
STEP 14 - Testing the Ultrasonic Stack
Scan Stack feature, press and hold the TEST
parameters displayed are Amplitude, Frequency, and Power
can Stack feature if any of
the stack component are changed.
STEP 16 - View the Weld Results


Figure 6-15 Cycle Data Tab
Cycle Data Tab
STEP 15 - Run a Weld Cycle
     
