22
8. PAPER FOLDING METHODS
The paper folding methods of this unit can broadly be divided into the following three types.
(1) Standard folding of standard paper
This is the basic paper folding operation of this unit. With this method, the “standard paper” designated by this
unit is set to the standard folding mode displayed on the control panel and paper folding is performed.
(2) Standard folding of non-standard paper (folding by entering paper length)
With this method, the length of paper other than the standard paper designated by this unit (this is called “non-
standard paper”) is registered, this paper is set to the standard folding mode displayed on the control panel, and
paper folding is performed. The length of the paper registered is calculated to match the standard folding mode,
and the positions (folding positions) of the folding stoppers of the folding plates are automatically set.
(3) Custom folding
Set the positions (folding positions) of the folding stoppers of folding plates 1 and 2 manually. As the stopper
position (folding position) can be specified, it allows non-standard folding to be performed freely.
There are certain restrictions (unfoldable areas) according to the paper length, folding plate length, etc. for the
above methods. For specific details of folding methods and restrictions, refer to the following chapters on
folding methods.
“9. STANDARD FOLDING OF STANDARD PAPER” (
☞
p.23)
“11. STANDARD FOLDING OF NON-STANDARD PAPER” (
☞
p.34)
“12. CUSTOM FOLDING” (
☞
p.37)
NoteNote
To Next Page
Loading...
