50
1
2
1
2
17. WHEN PAPER JAMMING OCCURS
17-6. When Paper Jams
Near Folding Plate 2
The right window shows “J1-3”.
Turn off the power.
1
Lock lever
No.2 connector
Control cord 2
Folding plate 2
Disconnect control cord 2 of folding
plate 2 from the No.2 connector, and
release the lock lever.
2
Remove folding plate 2.
q While slightly lifting the handle, slide folding
plate 2 downwards to the “2 ( )” mark.
w While slightly lifting the handle, further slide
folding plate 2 downwards and remove.
3
To ensure safety, be sure to follow the
above procedure. Performing this work
incorrectly may result in folding plate 2
dropping, injuries, or damage of folding
plate 2.
Be sure to hold folding plate 2 holding
the handle with both hands.
Do not subject folding plate 2 to shock,
otherwise it may damage, folding
accuracy will drop.
NoteNote
Open the top cover, and while rotating
the jam correction knob, pull out the
jammed paper.
4
Folding plate 2
After completing the above, set folding
plate 2 back to the original position.
Set folding plate 2 in the reverse order of step 3.
Secure at the “1 (
)” mark.
5
Push the lock lever towards “LOCK”,
and insert control cord 2 into the No.2
connector.
6
Rotate the jam correction knob to
check that folding plate 2 is secured. If
the knob rotates smoothly, it means
that folding plate 2 is secured.
If not secured properly, the right window will show
“-F2-” when the power is turned on.
7
Close the top cover.
8