32
Check for folding misalignment along
the vertical length of the paper from the
test folding results.
Check for folding misalignment using the second test
folded sample.
5
Folded paper
Correct folding misalignment along the
vertical length of the paper using the
folding stopper adjusting keys of
folding plates 1 and 2. (
☞
p.28)
6
After adjusting the folding
misalignment, press the adjustment
registration key until the buzzer
sounds “pi.pi...” (about two seconds).
When adjustment registration completes, the lamp of
the folding mode selected stops lighting and starts to
blink.
The adjustment value data registered is preserved
even after the power is turned off.
7
Blinking (End of adjustment registration)
10. FOLDING MISALIGNMENT
Correcting adjustment registration data
When the registration data of the paper size and folding mode
to be corrected is set again and registered according to the
above steps 1 to 7, the previous data will be rewritten.
Erasing adjustment registration data
Display the registration data of the paper size and folding
mode to be erased, and press the adjustment registration
key until the buzzer sounds “pi.pi...” for about two seconds,
and continue pressing for another two seconds until the
buzzer sounds “pi...” (total four seconds).
When the registration data is erased, the lamp of the folding
mode selected stops blinking and lights up.
The adjustment registration data must be erased
by registered paper size and folding mode. The
data cannot be erased for all sizes and modes
together.
NoteNote
Lit (When adjustment registration is erased)
To Next Page
Loading...
Need help?
General
