35
11. STANDARD FOLDING OF NON-STANDARD PAPER
Press the No. of sheets/Paper length
key and switch to the mode for entering
the paper length.
“L. ∗∗∗” is displayed on the right window.
(“
∗∗∗” is the value in the previous use.)
3
Using non-standard paper in settings for
standard paper will result in detection
errors due to the priority functioning of the
automatic paper size detection, and the
unit will not operate.
NoteNote
Measure the length of the non-standard
paper used, and enter the length using
the Paper length/Stacker roller position
key.
Pressing the “+” key increases the value, and pressing
the “–” key decreases the value.
The paper length which can be entered ranges from
5.1" to 17.0".
4
Register the entered paper length.
After entering the paper length, continue pressing the
No. of sheets/Paper length key until the buzzer
sounds “pi.pi...” (about two seconds).
When registration completes, “L.P” is displayed on the
left window, and the right window switches from the
paper length to the number of sheets to be processed.
5
The paper length data registered is
preserved even after the power is turned
off.
NoteNote
Lower the paper set lever and set the
paper feed tray.
2
Paper set lever
Press the folding mode key to select
the folding mode.
The registered paper length is calculated to match the
selected standard folding mode, and the positions
(folding positions) of the folding stoppers of folding
plates 1 and 2 are calculated.
6
To Next Page
Loading...
