QUICK START
Operation Procedure
Auxiliary paper feed tray
Power cord
Power switch
Paper receiving stopper
Paper receiving tray
Fixing screw
Paper feed
guides
1/2
Prepare the unit.
q Open the auxiliary paper feed tray.
w Open the paper receiving tray.
e Extend the paper receiving stopper.
1
This QUICK START is intended for outlining the main steps of the paper folding procedure to those who have read the
instruction manual once. Those who have not read the instruction manual should perform paper folding operations while
referring to the instruction manual.
NoteNote
Turn on the power switch.
Insert the plug of the power cord into the outlet, and
turn on the power switch.
2
Stack paper.
q Stack paper on the paper feed tray.
w Move the paper feed guides according to the
paper width, and tighten the fixing screws.
e Lower the paper set lever and set the paper
feed tray.
Adjust the paper feed guides to the
corresponding paper size on the paper feed tray
scale. If not adjusted to the appropriate scale, the
paper size will not be detected accurately and
this unit will not operate.
3
Perform test folding.
q Select the folding mode with the folding mode
key.
w Press the test key to perform test folding, and
check the finish.
4
Start paper folding operations.
Press the start key. Paper folding continues until the
paper feed tray becomes empty.
To stop halfway, press the stop key.
5
End paper folding operations.
q Turn off the power switch.
w Store the auxiliary paper feed tray, paper
receiving stopper, and paper receiving tray.
If not using the unit for a long time, disconnect
the power cord from the outlet.
6
Paper set lever
Example of
LTR paper
To Next Page
Loading...
Need help?
General
