17.7 Tool Parameter Set Up:
Set SP1-SP8 number to the related tools
Set the depth value of the tool
Click to test the knife tool depth, the knife tool will drop down
as much as per the tool depth value
Click to test the oscillating tool depth, the oscillating tool will
drop down as much as per the tool depth value
Click to test the wheel tool depth, the wheel tool will drop down as
much as per the tool depth value
To set the machine speed when you click the ↑↓←→ buttons
Temporary set the original position after moving the cutter head
with the ↑↓←→ buttons to a certain position of the table.
Click to feed a sheet or a certain distance of the roll sheet
Adjusting the deceleration of the K3 slash
Adjust the stop speed of K3 slash
Adjusting the cutting speed of the cutter
Adjust the stop speed of cutting slash
Lift the knife when set to how much angles tangent
Knife Established Set
Vibration knife speed
The speed at which the cutter performs the vibration cutter
instruction
Vibration knife acceleration
Acceleration of the cutter in the execution of the vibration cutter
cutting order
The speed of the cutter when executing the command of the
vibration cutting
Acceleration of the under
shock knife
Acceleration of the lower cutter when the cutter executes the
instruction of the lower vibration cutting
Angle of the cutter when executing the arc instruction of the
vibration cutting
To Next Page
Loading...
