Duplo DPC-600PKG - Page 71

- 70 -
Menu
Items
Functions
Tool selection
Speed &
Acceleration
SP1-SP8
To set the tools name
K3 Speed
K3 tool cutting speed
Cut Speed
Tangential tool cutting speed
Moving Speed
Machine moving speed after tools lifting up.
Cut Down Speed
The tools move down speed
Bending Speed
Machine processing curve/circle speed
K3 Acceleration
The cutter acceleration when it is working with the K3
tool
Cut acceleration
The machine move acceleration when it is working with
the knife tool
Move acceleration
The machine move acceleration when it is travelling
without tools working
Cutdown Acceleration
The tools move down acceleration speed
Advanced Settings
K3 down delay
The machine delays in N millisecond before the K3 tool
drops down
K3 up delay
The machine delays in N millisecond before the K3 tool
lifts
Cut down delay
The machine delays in N millisecond before the knife tool
drops down
Cut up delay
The machine delays in N millisecond before the knife tool
lifts
Wheel down delay
The machine delays in N millisecond before the wheel
tool drops down
Wheel up delay
The machine delays in N millisecond before the wheel
tool lifts up
Automatic repeat
Repeat the previous job automatically after activated
Automatic return to origin
After finished the job, the machine automatically back to
the origin position
Gradient
Gradient correction of the gantry
Restoration of factory
settings
Restore all machine parameters to pre-factory settings
Return
Return to the upper layer