DURKOPP ADLER 367 - Winding the Looper Thread

6.5 Winding on the looper thread
–
Pull the thread through the guide 3 and the tensioner 4.
–
Place the thread behind the blade 5 and sever it.
–
Fit the bobbin 1 onto the bobbin winder.
Hint
There is no need to wind the thread onto the bobbin by hand.
–
Press the bobbin-winder lever 2 into the bobbin.
–
Sewing
The bobbin-winder lever terminates the process as soon as the
bobbin is full.
The bobbin winder always stops in such a position that the blade 5
is in the insertion position (see r ight-hand illustration).
–
Remove the full bobbin 1, place the thread behind the blade 5 and
sever it.
–
Fit empty bobbin onto the bobbin winder for the next winding
process and press the bobbin-winder lever 2 into the bobbin.
CAUTION !
If the thread is not to be wound on during sewing, it is essential
for the sewing foot to be locked in the raised position and the
sewing-foot stroke set to the smallest value.
13
5
4321