7.3.5 Reducing the maximum rotation speed
The maximum speed can be reduced to adapt it to particular
applications.
After each c ompleted seam the current value of the maximum speed is
shown in the display. This value can now be directly changed with the
“+” and “ -” keys. The adjustment range lies between the values of
parameters F-111 (maximum value) and
F-121 (minimum value).
Caution !
Reducing the maximum rotation speed also reduces the rpm for
starting and ending bar tacks and f or counted seam sections
executed automatically.
7.3.6 Fast information display and settings entry (HIT)
When functions are switched on with keys 1, 2, 3, 4 and 9 the
associated values are displayed to the operator for about 3 seconds.
During this period the value can be changed immediately with the “+”
or “-” keys.
CAUTION !
The changed parameter values are not saved unless a complete
seam is sew n after leaving programming level, i.e. the pedal is
pushed forw ards and then all the w ay back.
If the drive is sw itched off straight after leaving programming
level, the changes are lost.
7.3.7 Entering the technician-level code number
See set-up instructions.
7.3.8 Seam programming with the V820 operating panel
A maximum of 8 programs with a total of up to 40 seam sections may
be saved.
The starting-bar-tack, ending-bar-tack, stitch-count, thread-cut and
foot-lift functions can be individually assigned to each seam.
For a description see the “EFKA DA82GA” operating manual.
28
To Next Page
Loading...
