DURKOPP ADLER 367 - Sewing Machine Operation by Subclass; Operation for Subclass 367-170010; -180010

9.2 Subclass 367-170115; -170315; -180115; -180315
The description of operation is based on the following preconditions:
–
The following functions are set on the operating panel:
Starting bar tack: ON
Ending bar tack: ON
Sewing-foot position before
and after
cutting DOWN
needle position before
cutting: DOWN (position 1)
–
Main switch on.
–
The last action was concluded with an ending bar tack and
thread-cutting.
Operating and function sequence:
Action Operation / Remarks
Before starting w ork
Initial position
Position material at start of seam
- Pedal in neutral position.
Sewing machine at a halt.
Needle up. Sewing foot down.
- Push pedal back.
The sewing feet rise.
- Position material.
- Release pedal.
The sewing feet descend onto the material.
At the start of seam
Starting bar tack and continue sewing
Do not se w sta rt in g ba r ta c k
- Push pedal forwards and hold it there.
The starting bar tack is sewn.
The machine then continues sewing at the
speed set by the pedal.
- Press key 3 (bar-tack suppression).
- Push pedal forwards.
- The machine sews at the speed
set by the pedal.
35
4
1234
*)
5
*)