DURKOPP ADLER 367 - Page 3

Content page:
7.3.4 Changing operator-level parameter values ............................... 27
7.3.5 Reducing the maximum rotation speed .................................. 28
7.3.6 Fastinformationdisplayandsettingsentry(HIT)............................ 28
7.3.7 Enteringthetechnician-levelcodenumber ............................... 28
7.3.8 Seam programming with the V820 operating panel........................... 28
7.4 EFKAcontrolsparameterlist........................................ 29
7.5 Status and error messages on the V810 and V820 operating panels ................ 30
8. Coupling-positioning actuator
8.1 General..................................................... 31
8.2 Operationofthe6F82FAsewing-drivecontrol ............................. 32
8.2.1 Operatingelementsinthe6F82FAsewing-drivecontrol ....................... 32
8.2.2 Keyfunctionsinthe6F82FAsewing-drivecontrol ........................... 32
8.2.3 Changing operator-level parameter values ............................... 32
8.2.4 Reducing the maximum rotation speed .................................. 33
8.2.5 Enteringthetechnician-levelcodenumber ............................... 33
8.3 6F82FA control operator-level parameter list .............................. 33
8.4 Status and error messages on the V810 and V820 operating panels ................ 33
9. Operation
9.1 Subclass 367-170010; -180010 ...................................... 34
9.2 Subclass -170115; -170315; -180115; -180315 ............................. 35
10. Maintenance
10.1 Cleaning and testing ............................................. 37
10.2 Lubrication ................................................... 39
4