10.8 Skip Stitch Device (SSD) FSE 13-1/2
Sewing Mode
In case of a skipped stitch during normal sewing, the motor stops and the LED shines.
The release of the motor can be done by the touch-key only.
Bobbin M ode
For bobbin winding, the SSD has to be switched on into the bobbin mode.
Hold the touch-key for 5 seconds onto the SSD.
After 5 seconds, the LED s tarts flashing indicating that the thread monitor is disabled.
Now you can start to wind a bobbin. By activating the foot pedal for thread trimming the
thread monitor is enabled again.
43
GB
To Next Page
Loading...
