5 Operation
5.1 Handpiece
On the Scaler LED handpiece, the Vector basic
unit generates a spatial vibration of the instru-
ment tip (transverse to the instrument axis) with
an amplitude of approx. 20–120 mm.
During treatment using the Scaler handpiece,
fluid is applied as a constant stream. The amount
of water that comes out can be adjusted via the
operating panel.
6 LEDs are integrated into the front section of the
handpiece. As soon as the flexible foot switch is
switched on and "Power" is selected on the
operating panel, the LEDs light up.
The LEDs go out approx. 4 seconds after the
flexible foot switch is released.
5.2 Fluid container
The fluid level is monitored via a sensor. When
the level drops to a minimum level, the LEDs in
the area of the fluid container flash and a warning
signal sounds (3x).
5.3 Instrument change
The instrument can be screwed in or out using
the torque wrench integrated in the Scaler tool
kit.
Product description
14 9000-615-32/02 2012V003
EN
To Next Page
Loading...
