31CA 251/301 M251EN2
SPECIAL INSTRUCTIONS
Standard oils and other
recommended fluids
On leaving the factory the various systems and
components are filled with oil or fluid as indicated in
Lubricant Specification, and are thus suitable for ope-
ration in ambient temperatures between -10°C (14°F)
and +40°C (104°F). The following recommendations
apply for operation in higher ambient temperatures up
to a maximum of +50°C (122°F):
The engine can be used at this temperature using
normal oil but for other components the following fluids
must be used:
Hydraulic system: Shell Tellus Oil T100, or equivalent.
Other components using transmission oil: Shell Spirax
HD 85W/140, or equivalent.
The temperature limits apply to standard versions of
the roller.
Rollers that are fitted with additional equipment, such
as noise suppression, etc, may require extra observa-
tion in the higher temperature ranges.
High pressure washing
A water jet should not be aimed directly at the
cap of the fuel tank or hydraulic reservoir.
This is especially important when using a
high-pressure jet.
Place a plastic bag over the cap and secure it with a
rubber band. This will avoid water entering the venting
hole in the filler cap, which would otherwise cause
operational disturbance and a clogged filter. Do not
spray electric components or the instrument panel.
In the event of fire in the machine, use an ABE-powder
fire extinguisher if possible. A BE type carbon dioxide
fire extinguisher may also be used.
Fire fighting
Absolutely no welding or drilling of holes is permitted
on the roll over protecting structure (ROPS). Never
repair a damaged structure, replace it with a new
ROPS.
When using an auxiliary battery, ie, in addition to the
one installed on the roller, to assist starting, always
connect the positive terminal of the auxiliary battery to
the positive terminal of the roller battery, and negative
to negative.
Roll over protecting structure
(ROPS)
Starting aid
CAUTION
Higher ambient temperature,
max. +50°C (122°F)
To Next Page
Loading...
