30 CA 251/301 M251EN2
LONG-TERM PARKING
The following instructions must be complied
with when parking or storing the roller longer
than one month.
The measures stipulated apply for a standstill up to 6
months.
The measures marked
j must be taken before using
the roller again.
Diesel engine
Battery
j See the manufacturer´s instructions in the engine
manual that accompanies the roller.
j Remove the battery from the roller, clean it, check
that electrolyte level is correct and charge the
battery once every month.
j Cover the air cleaner or its intake opening with
plastic foil or tape. The opening of the exhaust pipe
must also be covered. This is necessary to prevent
moisture from getting into the engine.
Fill the fuel tank completely, ie, to prevent
condensation and corrosion.
Drain off any condensed water from the hydraulic
reservoir.
j Drain the water tank completely, even hoses, filter
housing and the water pump must be emptied.
Remove all the sprinkler nozzles over the drum and
wheels.
Lubricate the steering articulation bearings and both
bearings of the steering cylinder with grease.
Grease the piston rod of the steering cylinder with
rust inhibiting grease.
Grease the engine hood hinges, seat slide rails,
revs control, and mechanism of the forward/reverse
control.
Ensure that tire pressure is at least 150 kPa (1.5
kp/cm
2
) (22 psi), 110 kPa (1,1 kp/cm
2
) (16 psi) for
CA 251A.
j Close the instrument protection cover on the steering
column. Cover the entire roller with tarpaulin. The
tarpaulin must be kept clear of the ground.
If possible, park the roller indoors, preferably in a
building with even temperature.
Fig. 55 Weather protection
Air cleaner, exhaust pipe
Fuel tank
Hydraulic reservoir
Sprinkler system (CA 251A)
Steering cylinder, hinges, etc.
Tires
CAUTION
Covers, tarpaulin
To Next Page
Loading...
