Maintenance - 2000h
ICC1200C-1EN3.pdf 2012-05-16
Emulsion tank - Draining
1
2
3
Fig. Pump system
1. Stop cock
2. Drain cock
3. Drain hose
Open the cock (1) and the drain cock (2), which is
located in the left step. The hose (3) facilitates draining
the emulsion fluid into a suitable receptacle.
When cleaning the tank, see Water tank - Cleaning.
The Emulsions tank is made of plastic
(polyethylene), and is recyclable.
The Emulsions tank is made of plastic
(polyethylene), and is recyclable.
Fuel tank - Cleaning
Fig. Fuel tank
1. Fuel tank
1
It is easiest to clean the tank when it is almost empty.
Pump out any bottom sediment using a suitable
pump, such as an oil drain pump. Save the oil in
a container and dispose of it in an approved
manner.
Pump out any bottom sediment using a suitable
pump, such as an oil drain pump. Save the oil in
a container and dispose of it in an approved
manner.
Keep in mind fire risk when handling fuel.Keep in mind fire risk when handling fuel.
The fuel tank is made of plastic (polyethylene)
and is recyclable.
The fuel tank is made of plastic (polyethylene)
and is recyclable.
94
To Next Page
Loading...
