Dynapac CC1200C - Sprinkler System; Wheels Check - Cleaning

Maintenance, 10h
ICC1200C-1EN3.pdf2012-05-16
Sprinkler system / Wheels
Check - Cleaning
1
2
Fig. Wheel rack
1. Filler cap
2. Nozzle (one for each tire)
Fill the rear tank with emulsion fluid; for example,
water mixed with 2% cutting fluid. Make sure that the
sprinkler nozzles (2) are not clogged. Clean them and
the filter if necessary. See under Sprinkler
system/Drum; Check - Cleaning, for detailed
instructions.
Check the tire treads now and then to see if any
asphalt compound has stuck. This can occur
before the tires are sufficiently warm.
Check the tire treads now and then to see if any
asphalt compound has stuck. This can occur
before the tires are sufficiently warm.
Fluids that are flammable or detrimental to the
environment must not be used in the emulsion
tank.
Fluids that are flammable or detrimental to the
environment must not be used in the emulsion
tank.
1
2
3
4
Fig. Nozzle
1. Sleeve
2. Nozzle
3. Gasket
4. Strainer
Dismantle the blocked nozzle by hand. Blow the
nozzle (2) and fine filter (4) clean with compressed air,
or install replacement parts and clean the clogged
parts later.
Wear protective goggles when working with
compressed air.
Wear protective goggles when working with
compressed air.
71