Dynapac CC1200C - Every 10 Hours of Operation (Daily); After the First 50 Hours of Operation

Maintenance - Maintenance schedule
ICC1200C-1EN3.pdf 2012-05-16
Remove all dirt before filling, when checking
oils and fuel and when lubricating using oil or
grease.
Remove all dirt before filling, when checking
oils and fuel and when lubricating using oil or
grease.
The manufacturer’s instructions found in the
engine manual also apply.
The manufacturer’s instructions found in the
engine manual also apply.
Every 10 hours of operation (Daily)
Refer to the contents to find the page number of the
sections referred to !
Pos.
in fig
Action CommentPos.
in fig
Action Comment
Before starting up for the first time on that dayBefore starting up for the first time on that day
6 Check the engine oil level Refer to the engine manual6 Check the engine oil level Refer to the engine manual
14 Check the hydraulic reservoir level14 Check the hydraulic reservoir level
3 Check for free circulation of cooling air3 Check for free circulation of cooling air
1 Fill the fuel tank1 Fill the fuel tank
7 Fill the water tank7 Fill the water tank
8 Check the sprinkler system/Drum8 Check the sprinkler system/Drum
9 Check the scraper setting/Drum9 Check the scraper setting/Drum
22 Check the spring loaded scrapers Optional22 Check the spring loaded scrapers Optional
21 Check the sprinkler system - tires21 Check the sprinkler system - tires
22 Check the scraper setting - tires22 Check the scraper setting - tires
19 Test the brakes19 Test the brakes
After the FIRST 50 hours of operation
See Contents to find the page number of the sections
referred to!
Pos.
in fig
Action CommentPos.
in fig
Action Comment
6 Change the engine oil and oil filter Refer to the engine manual6 Change the engine oil and oil filter Refer to the engine manual
6 Change the fuel filter Refer to the engine manual6 Change the fuel filter Refer to the engine manual
13 Change the hydraulic fluid filter13 Change the hydraulic fluid filter
10 Check bolted joints10 Check bolted joints
64