Maintenance, 10h
ICC1200C-1EN3.pdf 2012-05-16
Water tank - Filling
Fig. Water tank
1. Tank cap
1
Unscrew the tank cap (1) and fill with clean water.
Do not remove the strainer. See technical
specifications for the tank volume.
Unscrew the tank cap (1) and fill with clean water.
Do not remove the strainer. See technical
specifications for the tank volume.
Only additive: A small amount of
environment-friendly antifreeze.
Only additive: A small amount of
environment-friendly antifreeze.
Scrapers, fixed
Checking - Setting
Fig. Drum
1. Scraper blade
2. Adjusting screws
2
1
Make sure that the scrapers are undamaged. Adjust
the scrapers so that they are 1-2 mm from the drum.
For special asphalt compounds, it may be better if the
scraper blades (1) lie lightly against the drums.
Asphalt remnants can accumulate on the scraper and
affect the contact force. Clean as required.
Loosen the screws (2) to adjust the contact pressure
of the scraper blade against the drum.
Remember to tighten all the screws after any
adjustment.
Scrapers, spring-action (Optional)
Checking - Adjustment
Fig. Spring-action scrapers
1. Scraper blade
2. Adjusting screws
2
2
1
The scrapers must be lifted from the drum during
transport.
The scrapers must be lifted from the drum during
transport.
72
To Next Page
Loading...
