Dynapac CC142C User Manual

13
CC 102/C/122/C/132/142/C O102EN3
2
1
Fig. 9 Left side of engine
1. Battery disconnecter
2. Hourmeter
Battery disconnecter
– Switching on
1
2
Sprinkler system/tires
Fig. 11 Emulsion tank
1. Filler cap
2. Sprinkler pipe
3. Fastening screws
1
2
Sprinkler system/drum
Fig. 10 Water tank
1. Filler cap
2. Sprinkler pipe
Fill the rear emulsion tank with water and possibly
cutting oil. Mixing 2–4% cutting oil (Fileum) in the
sprinkler water for the tires can prevent fastening.
Make sure that the sprinkler pipe (2) is in position to
give satisfactory spreading of water mist over the tires.
Slacken the fastening screws (3) of the pipe clip to
adjust the pipe.
Inspect the tire tread now and then to detect asphalt
compound that has fastened. This is likely until the tires
are sufficiently warm.
Fill the front water tank, and check that the sprinkler
pipe (2) is in position to distribute water mist over the
whole surface of the drum. Loosen the fastening
screws (3) of the pipe clips to adjust the pipe; see
figure below.
3
BEFORE STARTING
Remember to perform daily service. See the operation
manual.
The battery disconnecter is located in the engine
compartment. Turn the key (1) to the ON position. The
entire roller is now powered.
Item (2) is the engine hour meter. The number of hours
is counted as long as the engine is running.
The engine hood must be unlocked during
operation, so the battery power can be
disconnected quickly if necessary.

Dynapac CC142C Specifications

General

Brand	Dynapac
Model	CC142C
Category	Construction Equipment
Language	English