16
CC 102/C/122/C/132/142/C O102EN3
Starting the engine
Set the vibration switch (5) for manual/automatic vibra-
tion to the O mode.
Set the rev control (19) to idling mode. (On certain
versions, the control is located on the right side of the
instrument column.)
Turn the ignition switch (2) to the right to position I.
Press the starter switch (4). Release the starter switch
as soon as the engine fires.
Fig. 18 Instrument column
2. Ignition switch
4. Starter switch
5. Vibration switch
6. Reserve/parking brake knob
8. Charging lamp
9. Brake warning lamp
10. Oil pressure lamp
19. Rev control
659
4
2
Fig. 17 Forward/reverse lever
21
19
Set the forward/reverse lever (21) in neutral. The
engine cannot be started if the lever is in any other
position.
On certain versions, the F/R lever is located at the side
of the instrument panel, but the function is the same.
STARTING
Do not run the starter motor too long;
preferably wait a minute or so if the engine
does not start.
Warm up the engine at idling speed for a few minutes,
longer if the ambient temperature is below +10°C
(50°F).
Check while warming up that the warning lamps for oil
pressure (10) and charging (8) are out. The warning
lamp for the parking brake (9) should still light.
Remember that when you start and drive a
cold machine, the hydraulic fluid is cold
and the braking distance will be longer
than normal until the machine reaches
normal working temperature.
Make sure that ventilation (extraction) is
adequate if the engine is run indoors. Risk
of carbon monoxide poisoning.
810
To Next Page
Loading...
Need help?
General
