2017-11-22 4812325556EN 33
View
Before starting the machine, make sure that the view forwards
and backwards is unobstructed.
All cab windows should be clean and the rear view mirrors
should be correctly adjusted.
Operator position
If a ROPS (2) (Roll Over Protective Structure) or a cab is
fitted to the roller, always wear the seat belt (1) provided and
wear a protective helmet.
Replace the seat belt (1) if it shows signs of
wear or has been subjected to high levels of
tension.
Check if the rubber elements (3) on the platform
are in good condition. Worn elements will impair
the comfort.
Make sure that the anti-slip protections (4) on
the platform are in good condition. Replace
where anti-slip friction is poor.
If the machine is fitted with a cab, make sure
that the door is closed.
Interlock
The roller is equipped with an interlocking system.
The engine switches off from 4 to 7 seconds after the operator
rises from the seat with the forward/reserve lever still engaged
(not in the neutral position).
The engine does not switch off when the parking brake is
engaged.
To Next Page
Loading...
