2017-11-22 4812325556EN 73
TAKE CARE OF THE ENVIRONMENT: All used
coolant shall be properly collected and store for
subsequent recycling. Do not dispose of the
coolant on the ground, sewage system or other
place which can harm the environment.
4. Unscrew the hexagon nut, remove the hose and unscrew
the drain plug. Drain all the fluid to the container.
5. After the replacement, tighten the drain plug and fit back
the hose and the hexagon nut.
Empty and clean the fuel tank
NEVER perform maintenance work under the
machine when the engine is working. Always park
the roller on a flat and safe place and chock the
tires.
The fastest and simple way to clean the tank is when it is empty:
1. Open the filling cap (1) of fuel tank.
2. Place two proper containers under the drain plug of the fuel
tank (2).
The drain plug of the fuel tank is on the right side of
the machine, in a proper compartment.
3. Unscrew the drain plug (2) and drain the remaining fuel
inside the tank.
4. Refit the drain plug and tighten it.
Using adulterated, contaminated, dirty or bad
quality fuel damages the injection system and
engine components. The repairs due the conditions
above are NOT covered by the warranty.
TAKE CARE OF THE ENVIRONMENT: All the used
waste shall be properly stored for subsequent
recycling. Do not dispose of any waste on the
ground, sewage system or other place which can
harm the environment.
Be extremely careful when handling fuel. There
is risk of fire.
Fig. – Fuel tank
1. Filling cap
Fig. – Fuel tank draining
2. Plug
To Next Page
Loading...
