Dynatronics Dynatron 850 Plus - High Volt Probe (optional accessory)

Dynatron® 850plus & 550plus
Installation & Features
17
in place of the ground probe. This is particularly convenient when treating in several
different places around one point.
Ground Electrode: You can use an electrode in place of the ground probe. Just unplug the
ground probe from its cable, attach a banana-to-pin adapter to the cable, then attach an
electrode to the pin. Place the electrode on the patient at a site where it will not interfere with
placement of the active probe during treatment. The banana-to-pin adapter is an optional
accessory available from Dynatronics.
High Volt Probe (optional accessory)
An optional probe may be purchased which
allows you to deliver an attended high volt
treatment. The high volt probe is connected to
the dedicated high volt jack (HV) on the front
of the machine. The probe is used in
conjunction with a large dispersive electrode.
The high volt probe is used only for delivering
high volt therapy.
Complete setup and use instructions are
provided in this manual under the treatment
setup instructions for high volt.
High Volt Probe (optional accessory)