Dynatron® 850plus & 550plus
Treatment Instructions - ULTRASOUND
49
Turn Soundhead Warming Off / On
If you do not wish to use the head warming feature, you can turn the feature off with the
following key press. The head warming setting is saved and will apply to the device
whenever it is used until you change the setting again. These key presses are only necessary
if you want to change the current state of head warming.
• Press and hold the FUNCTION while pressing the SOUND key to turn soundhead
warming off or to turn it on again. The device will beep and the Time display will show
the selection made as follows:
HD 1 = Head warming on
HD 0 = Head warming off
• Press STOP after selecting the desired setting.
Basic Ultrasound Setup
1. Press the SOUND / COMBO key once to select SOUND.
2. Choose the FREQUENCY.
3. Choose the DUTY CYCLE.
4. Change the treatment TIME, if desired.
5. Raise POWER.
6. Press START.
7. Press STOP if you need to stop a treatment before its time has expired.
Detailed Ultrasound Setup
1. Press the SOUND / COMBO key once.
When you press the SOUND/COMBO key once, the SOUND LED is lighted, and the
ultrasound treatment default settings are automatically selected. If you wish to use the
default settings, increase the power, then press START. If you wish to use other settings,
do the following:
2. Choose the FREQUENCY.
Press the frequency toggle key one or more times to choose 1, 2, or 3 MHz. Any one of
the three frequencies may be selected with the 2 cm
2
, 5 cm
2
and the 10 cm
2
soundheads.
The 1 cm
2
soundhead offers 2 and 3 MHz.
3. Choose the DUTY CYCLE.
Press the duty cycle toggle key one or more times to select the desired duty cycle.
Available options include 10 percent, 20 percent, 50 percent, and Continuous duty cycle.
To Next Page
Loading...
