Dynatronics Dynatron 850 Plus - Page 63

Dynatron® 850plus & 550plus
Treatment Instructions - ULTRASOUND
55
• The default power display
is W/cm
2
. If you change
the display to WATTS
during use, the machine
reverts to the W/cm
2
display when the machine
is turned off and on again.
However, if you save
ultrasound default settings
while using the WATTS
display, the WATTS
display will become the
default
display for your
machine.
• You can tell when you have
selected WATTS display
by the decimal in the
display window.
- A steadily-lighted decimal means the power is displayed in W/cm
2
.
- A blinking decimal means the power is displayed in WATTS.
Press and hold the PAUSE/FUNCTION key for
two seconds. The machine will beep once to
indicate you have changed the display.
POWER-INTENSITY
PAUSE
FUNCTION
STOP
START
A non-blinking decimal = Power displayed in Watt/cm
2
A blinking decimal = Power displayed in Watts
Dynatron 850plus Power Display. You can view
power in either W/cm
2
or WATTS.