Dynaudio Sub 3 User Manual

36
CAUTION
Damage of small satellite speakers
Selecting the correct frequency
depends to a large extend on the main
speakers. Sometimes main speakers
are specically intended to work with
a subwoofer. In such cases, the main
speakers can get damaged by a full-
range amplier signal.
If in doubt, check the instruction
manual for the main speakers for any
restrictions.
The table on the next page offers some
setting tips for different speaker and
amplier combinations. This should
only be taken as rough guidelines, as
the best setup can just be found by
experimenting.
Many processors/receivers provide
extensive bass management capabilities
to set the cut-off frequencies for both
subwoofer and speakers. If using the
bass management of the processor/
receiver, set the controls of the Sub3 as
followed:
• SUB Lowpass = 150Hz
(at the very right)
• SAT Highpass = Flat
Specic tips
k
er
s
ai
n
s
t
h
n
-
n
o
r any
o
me
d
a
s

Dynaudio Sub 3 Specifications

General

On/off switch	Yes
Product color	Black
AC input voltage	100 - 240 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.5 W
Subwoofer type	Active subwoofer
Number of subwoofers	1
Subwoofer peak power	300 W
Subwoofer driver diameter	240 mm
Subwoofer frequency range	22 - 175 Hz
Subwoofer crossover frequencies	60 - 80 Hz
Line inputs (RCA)	3

Weight and Dimensions

Subwoofer depth	320 mm
Subwoofer width	266 mm
Subwoofer height	276 mm
Subwoofer weight	10500 g