Dynaudio Sub 3 User Manual

23
Selecting the subwoofer cut-
off frequency
(SUB Lowpass)
The SUB Lowpass control allows the
frequency range of the subwoofer to be
dened. Above the selected frequency
the sound level decreases rapidly.
The correct setting of this cut-off
frequency is important for a well
balanced combination of subwoofer and
speakers.
To select the cut-off frequency:
Set the SUB Lowpass control to the
desired frequency between 50 and 150Hz.
Operation
Note
In most audio-video-systems the subwoofer cut-off frequency is already set in
the bass management of your processor/receiver. Please refer to the operating
manual of your processor/receiver for further information. If possible, switch
off any settings. If your processor/receiver does not allow to switch off the
bass management, set it to the desired frequency and set SUB Lowpass to its
maximum value (turn to the very right, 150Hz).
Please also heed the instructions given in the operating manual of your
loudspeakers, and refer to “Cut-off frequencies” on page 25 for further
information.
SUB LowpassSAT Highpass
50Hz 150Hz
60HzFlat 80Hz

Dynaudio Sub 3 Specifications

General

On/off switch	Yes
Product color	Black
AC input voltage	100 - 240 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.5 W
Subwoofer type	Active subwoofer
Number of subwoofers	1
Subwoofer peak power	300 W
Subwoofer driver diameter	240 mm
Subwoofer frequency range	22 - 175 Hz
Subwoofer crossover frequencies	60 - 80 Hz
Line inputs (RCA)	3

Weight and Dimensions

Subwoofer depth	320 mm
Subwoofer width	266 mm
Subwoofer height	276 mm
Subwoofer weight	10500 g