13
Connecting sources directly
► Connect your source cables to one or more of the audio inputs
Aux
,
Line
,
Opt
of the master speaker
(see „Connection options“ on page 18).
After it is turned on, the speaker automatically searches for an audio signal and then plays it back
immediately. If several signal sources are active, one of the signal sources will be played back.
TIP:
For easier access, the plate at the bottom of the cabinet can be removed. Use a coin or
screwdriver to loosen the screw and attach the plate after connecting the power cable.
Connecting a Bluetooth device
1. To begin Bluetooth pairing, press and hold both and buttons on either one of your speakers.
▼ Once available for pairing, the Xeo 2 status indicator will blink white and it will be available for
pairing for one minute.
2. Go to settings on your device, nd the submenu Bluetooth, and simply pair your device with your
Xeo 2 by selecting Red, Green, or Blue. The speaker will store your pairing.
Connecting sources via Hub or Connect
Xeo Hub and Dynaudio Connect are optional components that allow you to connect analog and digital
sources and are linked with Xeo 2 via Bluetooth. For further information about the complete Xeo
system, please see „The Xeo system“ on page 20.
To Next Page
Loading...
