Dynaudio Xeo 2 - Volume and Standby Modes; Fixing the Volume; Standby Modes

15
Fixing the volume
You can set the speaker to a higher volume using the function to x the volume. This setting also
remains in effect in standby mode. If a signal source is connected to the Xeo 2 with its own volume
control, you have the option to change the output volume across a broad range with the signal source.
To x the volume:
► Point the remote control at a speaker and press for at least 2 seconds. To undo xing, press
one of the two volume buttons.
Standby
To switch speakers to sleep mode:
► Point the remote control at a speaker and press or press on top of one of the speakers.
▼ The speakers will enter sleep mode.
▼ The speakers also enter sleep mode if there is no audio signal for 20 minutes.
▼ In this mode, the wireless network is active and all connected units remain synchronized.
▼ Sleep mode power consumption is <2 W.
To switch speakers to low-power standby mode:
► Press and hold
on the remote control for at least 5 seconds.
▼ The speakers go to low-power standby mode.
▼ In this mode, the wireless network is disabled and the speakers are not connected to each
other.
▼ Low-power standby mode power consumption is <0.5 W.
To turn off auto standby:
► Press and hold
Opt
on the remote control for at least 5 seconds.