Dyness Tower T21 - Safety Gear; Unpacking

Tower ESS User Manual
©Dyness reserves the copyright of this document.
17
Figure 3-3 Installation tools
CAUTION
Use properly insulated tools to prevent electric shock or short circuit.
Safety Gear
We recommend wearing the following safety gear when working with batteries:
Insulated gloves
Safety goggles
Safety shoes
Figure 3-4 Safety gear
Unpacking
When the battery system is delivered at the installation site, unloading should be
performed according to the rules and regulations, to prevent being exposed to direct
sunlight. Batteries should not be installed in locations in direct sunlight. See Figure 3-2
Installation location precautions.
Before unpacking, the total number of boxes must be reconciled according to the
shipping list attached to each package, and the boxes must be checked for good
condition.
Handle all items carefully and protect the surface coating of the items.
Crimping tool
Pen
Phillips screwdriver Flat screwdriver
Wire Stripper
Hydraulic crimping tool
Wrench
Tape Measure
Hair Dryer
Socket wrench
Torque Wrench
Drilling machine