Before installation or operation carefully read the “Tower ESS User Manual”.
The batteries will produce high voltage DC power and might cause lethal voltage and
electric shock.
Only qualified persons are allowed to wire the batteries.
This product is a high voltage DC system, and should be operated by authorized persons
only.
Risk of battery system damage or personal injury.
DO NOT disconnect while the system is running!
Keep all power sources off and verify that they are de-energized.
Battery damage may result in electrolyte leakage. If the electrolyte is leaked, do not touch
the leaked electrolyte or volatile gas, and contact the after-sales service team for help
immediately. If leaked material was touched accidently, please follow the steps below:
Inhalation of leaked material: Evacuate from contaminated area and seek medical
assistance immediately.
Eye contact: Flush with clean water for at least 15 minutes and seek medical assistance
immediately.
Skin contact: Wash the contact area thoroughly with soap and clean water and seek
medical assistance immediately.
Ingestion: Induce vomiting and seek immediate medical assistance.
Do not move the battery system if it is connected with an external expansion module.
If you need to replace or add a battery, please contact the after-sales service center.
Risk of battery system failure or life cycle reduction.
Before Connecting
Please check product and packing list after unpacking. If the product is damaged or parts
are missing, please contact the local dealer.
Before installation, make sure that the grid is disconnected and the battery is switched off.
Do not invert the positive and negative cables and ensure there is no short circuit to the
external device.
It is prohibited to connect the battery to AC power directly.
The battery system must be properly grounded and the resistance must be less than 1Ω.
Ensure that the electrical parameters of the battery system are compatible with the
respective equipment.
To Next Page
Loading...
