Dynisco 1480 - Strain Gauge Calibration Mode

From lab to production,
providing a window into the process
-11-
www.dynisco.com
Rev: n/aP/N: n/a ECO: n/a
Note: Operator mode screens follow, without exing from Setup mode.
5. Strain Gauge Calibraon Mode
Note: Conguraon must be completed before adjusng Calibraon parameters. First select
Calibraon mode from Select mode (refer to secon 2). Press to scroll through the parameters
(while this key is pressed, and for 1 sec aer, the parameter legend is shown, then the current value).
Press or to change the value. To exit from Calibraon mode, hold down and press to
return to Select mode.
Note: Calibraon mode will only be displayed if input type is set to St_G