EN
ENTER 40
32
6.2.1 Satellite settings
Add satellites:
Press RED to add a new satellite, in which you must input an unique longitude,
and edit the satellite's name with soft keyboard.
Edit satellites:
Press GREEN to edit the focused satellite.
Delete satellite:
Press YELLOW to delete the focused satellite.
Press OK to confirm.
6.2.2 Transponder
Press EPG to switch the list to show transponders of the focused satellite. Also
you can press EPG to switch back to satellites' list.
Add transponder:
Press RED to add a new transponder. It can't save an existing TP under the
same satellite.
Edit transponder:
Press GREEN to edit the focused transponder. It can't save an existing TP
under the same satellite.
Delete transponder:
Press YELLOW to delete the focused transponder. Press OK to confirm.
Single Transponder Scan:
Press BLUE to pop the menu of scanning setting. After configuring the settings,
Press OK to start scanning.
Multi-Transponder Scan:
Press OK to select transponders with the mark"",then press BLUE to pop the
menu of scanning setting. After Configuring the settings, press OK to start
multi-transponder scanning.
6.2.3 Channel search
Single Satellite Scan:
Press BLUE to pop the menu of scanning settings.
Scan Mode:
Press / to select default, which scans the default transponders built in
and NetWork, which scan with NIT on.
Crytped:
Press /to select All Channels or FTA Channels;
Service Type:
Press /
to select ALL, DTV or Radio.
Press OK to start scanning with the above settings.
Multi-Satellites Scan:
Press OK to select satellites with the mark " “, then press BLUE to pop the
To Next Page
Loading...
