Service manual
Fitting notes
96 Apply one spot of glue to the four
locations shown.
Fit the cyclone exhaust seal onto
the main chassis.
97 Peel the top edge of the exhaust
seal from the main chassis.
Position the front of the tool
storage onto the main chassis.
Lower the rear onto the retainer
of the duct cover.
Slide the main cassis to lock.
Fit the screw.
98 Locate the castor wheel and axle
into the castor body. Firmly press
the castor body onto the base of
the main chassis.
39
After fitting, the following parts should be fitted as previously shown:
Motor bucket assembly (pages 27-31)
Cable rewind assembly (pages 14-21)
To Next Page
Loading...
