45
Now that you have confirmed proper response of the tail motor/rotor to gyro and transmitter inputs, it is time to
proceed with initial adjustments of the gyro mode and gain setting, and to conduct test flights.
• If you are using the G90 gyro, and have chosen not to utilize the remote mode and gain setting
control option, set the gain setting adjustment pot on the gyro to a value of approximately 50%
before conducting the first test flight after installing the gyro. This gain setting adjustment pot on the
gyro is the same pot that you will use for adjusting the gyro gain value after conducting test flights.
• If you are using the G90 gyro, and have chosen to utilize the remote mode and gain setting control option, you
will need to use the Channel 5 knob on the transmitter for setting the mode type and gain value, as outlined in
the following steps:
To Next Page
Loading...
