46
When the Channel 5 knob is in the middle position, pointing directly to the rear of the transmitter, the gain setting
value will be approximately 0% for either the Standard Rate or Heading Lock modes. This point will be used for
reference only as it is not generally preferred to fly with the gyro gain setting at a value that is so low.
When the Channel 5 knob is rotated counterclockwise (-) from the middle position, the gyro will be in the
Standard Rate mode. This mode is the same as offered by the 3-in-1 control unit’s stock gyro. When the knob
is rotated full counterclockwise, the gain setting value will be approximately 100%. Other gain setting values
from approximately 0–100% are also available depending on where the knob is set between the middle and full
counterclockwise positions.
To Next Page
Loading...
