E-Mu Classic keys User Manual

74
EDIT MENU
KEYBOARD & VELOCITY MODULATION
These functions allow you to route
keyboard and velocity information to any
of the modulation destinations on Classic
Keys. Up to 6 simultaneous paths or
“patches” may be programmed. For each
modulation patch, there is a source
(keyboard or velocity), and a correspond-
ing amount parameter which is variable
from -128 to +127. Place the cursor
under the appropriate parameter and
change the patch number, modulation
source, modulation destination, or the
amount using the data entry control. If a
parameter is not labeled either primary or
secondary, it will affect both.
KEY/VELOCITY CTL
1 V>Attack -064
THE TONE FILTER IS A
SIMPLE LOW-PASS TONE
CONTROL WHICH CAN BE
USED TO DARKEN THE
TONE OF AN INSTRUMENT.
MODULATION SOURCES:
KEY NUMBER
KEY VELOCITY
DESTINATIONS:
PITCH, PRIMARY PITCH,
SECONDARY PITCH,
VOLUME, PRIMARY VOLUME,
SECONDARY VOLUME,
ATTACK, PRIMARY ATTACK,
SECONDARY ATTACK,
DECAY, PRIMARY DECAY,
SECONDARY DECAY,
RELEASE, PRIMARY RELEASE,
SECONDARY RELEASE,
CROSSFADE,
LFO 1 AMOUNT,
LFO 1 RATE,
LFO 2 AMOUNT,
LFO 2 RATE,
AUX. ENVELOPE AMOUNT,
AUX. ENVELOPE ATTACK,
AUX. ENVELOPE DECAY,
AUX. ENVELOPE RELEASE,
SAMPLE START,
PRIMARY SAMPLE START,
SECONDARY SAMPLE START,
PAN, PRIMARY PAN,
SECONDARY PAN,
TONE, PRIMARY TONE,
SECONDARY TONE

E-Mu Classic keys Specifications

General

Brand	E-Mu
Model	Classic keys
Category	Electronic Keyboard
Language	English