113
Navigate a trail menu sequence: Fig. 1, My Trails command. Fig. 2,
Trails Menu. Fig. 3, Edit Trail Menu. Fig. 4, Edit Route Menu with
Navigate command highlighted for Trail 6. A trail is always converted
to a route when you navigate the trail.
On the Map Page, the trail you are navigating is represented by a
flashing line. The Navigation Page will also show the navigated trail as
a flashing line. The bearing arrow on the compass rose points to the
next waypoint on the trail. The arrival alarm will go off when you near
a trail waypoint and the bearing arrow on the compass rose will swing
around and point to the next waypoint. Press
EXIT to clear the alarm.
Figure 3.
Figure 4.
Figure 1.
Figure 2.
www.Busse-Yachtshop.de email: info@busse-yachtshop.de
To Next Page
Loading...
