Eagle Nebula - Check Weighing Setup (Wt)

16
| P a g e
1. Check Weighing (Wt)
When ENTER key is pressed from “CHC Wt”, the display will show the ‘LOC W1’.
Default Location is W1.
Total 9 locations are available to enter the low limit, high limit, buzzer
status, threshold value.
When ENTER key is pressed from “LOC W1”, the display will show the
‘W1 LL’.
Use Zero key for the increment and Tare key for the decrement to
scroll between LL, HL, bZ and tH.
When ENTER key is pressed from “W1 LL”, the display will show the
‘000.000’. Default value is 000.000.
Use Zero key for the increment and Tare key for the decrement and
N/G key for the shift.
Once the value is entered as per requirement, press ‘ENTER’ button to
select, and after selection the display will go to the previous menu.
When ENTER key is pressed from “W1 HL”, the display will show the
‘000.000’. Default value is 000.000.
Use Zero key for the increment and Tare key for the decrement and
N/G key for the shift.
Once the value is entered as per requirement, press ‘ENTER’ button to
select,and after selection the display will go to the previous menu.
When ENTER key is pressed from “W1 bZ”, the display will show the
‘bZ In’. Default value is In.