Eagle Nebula - 4.1.11 RS232 Leading Zero Transmission

32
| P a g e
If we keep Y (Yes) in this setting, then if the weight in the display is
8.532, then in the RS232 it will be transmitted as +8.532
Press ‘ENTER’ button to select,and after selection the display will show the
SG Y or SG n as per the selection.
Press Tare key to go to the next parameter.
4.1.11 Leading Zero (LZ) :
When ENTER key is pressed from “LZ Y”, the display will start flashing ‘Y’.
Default value is Y.
This setting decides whether the leading zero before the weight value
should be transmitted in the RS232 string or not. Use Zero & Tare Key to
choose Y or N and press ENTER key.

Y - Yes (To transmit leading zero)

N-No (Do not transmit leading zero)
If we keep Y (Yes) in this setting, then if the weight in the display is
8.532, then in the RS232, it will be transmitted as 008.532 (Leading
zeros will be added in prefix to the weight)
Press ‘ENTER’ button to select,and after selection the display will show LZ
Y or LZ n as per the selection.
Press Tare key to go to the next parameter.