35
| P a g e
Press ‘ENTER’ button to select either E or D and after selection the display
will show show the selected value.
Press Tare key to go to next parameter.
4.2.2 Bluetooth Name (NA)
When ENTER key is pressed from NA d or NA E, the display will show
‘000000’. Default value is 000000.
Here we can enter 6 characters or digits as the name for the bluetooth
to identify. We can use any alphabet or numbers to set the device
(bluetooth) name.
Use Zero and Tare key for increment and decrement of the values and
use N/G key for left shift to enter the name.
Press ‘ENTER’ button and the display will show the entered name.
Press Tare button to go the next parameter.
4.2.3 Pin (Pn)- For Engineering purpose.
4.2.4 Data Out (dOUt)
It is same like RS232 settings. Refer section no. 4.1.5.
4.2.5 Transmission mode (tr)
It is same like RS232 settings. Refer section no. 4.1.6.
To Next Page
Loading...