Eagle Nebula - Check Counting Buzzer Settings; Check Counting Threshold Values

19
| P a g e
Once the value is entered as per requirement, press ‘ENTER’ button to
select, and after selection the display will go to the previous menu.
When ENTER key is pressed from “C1 bZ”, the display will show the
‘bZ In’. Default value is In.
Use Zero key for the increment and Tare key for the decrement for
selection
 In -If the No. of Pieces is between LL and HL then the buzzer
start ringing.

OUt- If the No. of Pieces is outside the LL and HL then the
buzzer start ringing.
Once the In or out is chosen as per requirement, press ‘ENTER’ button
to select,and after selection the display will go to the previous menu.
When ENTER key is pressed from “C1 tH”, the display will show the
‘000000’. Default value is 000000.
Use Zero key for the increment and Tare key for the decrement and
N/G key for the shift.
Check counting will happen if the current display value is greater than
the threshold value
Once the value is enter as per requirement, press ‘ENTER’ button to
select, and after selection the display will go to the previous menu.
(Note: - Same process can be followed to enter the pre define values for
locations from C2 to C9.)