Eaton 9PX Lithium-Ion User Guide P-164001006—Rev 02 13
Table 6. User Settings (Continued)
Submenu Available Settings Default settings
commands from software are
authorized.
Shutdown commands [Send CMD] [Output OFF] [OFF
delay] [restart]
Sets events or fault that will
actuate Output signal
parameters through external
contact connector or RS232
port
[Send CMD]: [Yes] [No] Send CMD: [No]
[Output OFF]: [No] [UPS]
[Group 1]
Output OFF: [No]
[Group 2] [Group 1 + Group 2]
[OFF delay]: [0s] …[999s] OFF delay: [0s]
[Restart]: [Yes] [No] Restart: [Yes]
On battery notice delay Sets delay before noticing on
battery information to
software.
[0s]
General alarm [On battery] [Battery fault] [Internal fault]
[Overload pre-alarm] [Internal
fault]
[Ambient temp.] [Fan lock]
[Bypass overload] [Current
limit]
[Short circuit] [Inverter
overload]
[Power overload] [Low battery]
[On bypass] [UPS OK] [Load
protected]
[Load powered] [Ext. charger
ON]
Defines which event or fault
generate
a general alarm through
Output signal screen.
User Settings
To Next Page
Loading...
