76
8 Operating
Mounting and Operating Instructions CEAG Central Battery System ZB-S 40071860179 (L) November 2018 www.ceag.de
Displaying
Time and date (line 0)
Operating mode (line 1)
present voltage and current
value (line 2)
Fault information (line 3)
Status of mains supply at control
unit (line 4)
Device name (line 5)
Keypad
ESC key <ESC>
Menu key
ok key <ok>
and cursor keys
Memory card for saving and data
transmission of test log and parame-
ter settings
Control module
CU CG-S
1 Test & status menu
1. 1
Start functiontest
1. 2
Start durationtest
1. 3
Cancel durationtest
1. 4
Sum failure info
1. 5
Circuit state
1. 6
Luminaire state
1. 7
DLS/TLS/3PhW state
1. 8
Charging/Bat. state
1. 9
Relay state
1. 10
Substation state
Main menu
Main screen (Example)
1.
Test & status menu
2.
Block & reset alarms
3.
Basic settings
4.
DLS/TLS setup
5.
Circuit setup
6.
Luminaire setup
7.
Logbooksetup
8.
Send ServicePinMsg
MULTI-MASTER MODE M3:
In Multi-Master Mode the following func-
tions are possible to activate:
Start FT
Start/cancel DT
Substation-status (display)
Block/release device
Date/Time (set)
Automatic FT (specify)
Automatic DT (specify)
Previously, the substation needs to be
found in the menu «Main settings /
Substation setup».
Before the execution of the command
there is a request in the Mulit Master
Mode if this system-no. or all systems of
one group should execute this command.
The M3 function can only be executed
when all control units are interconnected
over the CG-S bus and no CGVision or a
CG controller is used.
Operation is the same for ZB-S
systems and for their US-S
substations.
If password protection is activated,
then only the main screen and the
main menu options “1 Test and
Status Menu” and “2 Block, Reset”
are accessible without entering a
password.
The controller software automatically
returns to the main screen if no entry
is made within 180 seconds.
The LCD display backlighting goes
off if no entry is made within 180
seconds. Pressing any key switches
the backlighting on again.
The contrast and brightness (LCD
backlighting) can be adjusted in the
main screen when the <ok> key is
pressed:
<ok> + / : contrast adjustment
<ok> + / : brightness adjustment
These parameters can also be set with
menu option “3.10 Display Setting” in
menu “3 Basic Settings”.
Here the parameters can be numerically
set as percentages.
To Next Page
Loading...
