iiiINSTALLATION AND OPERATION INSTRUCTIONS MN280084EN July 2018
Contents
DISCLAIMER OF WARRANTIES AND LIMITATION
OF LIABILITY ...............................II
SAFETY FOR LIFE ..........................IV
SAFETY INFORMATION .....................IV
Safety instructions ..........................iv
PRODUCT INFORMATION .....................1
Introduction ............................... 1
Read this manual first ....................... 1
Additional information ....................... 1
ANSI standards ............................ 1
Quality standards. . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Acceptance and initial inspection .............. 1
Handling and storage ........................ 1
Control power ............................. 1
FORM 6 TRIPLE-SINGLE CONTROL DESCRIPTION 2
Description ............................... 2
Theory of operation ......................... 2
Control front panel .......................... 4
Control features ............................10
Communications .......................... 13
Control information ........................ 13
Control back panel ......................... 13
INSTALLATION PROCEDURE .................15
Initial programming prior to installation ......... 15
Control/Recloser compatibility ................ 15
Duty cycle monitor ........................ 15
Recloser connections ...................... 15
Customer-supplied shielded control cable ....... 16
Junction box and cables .................... 16
Mounting the control ........................17
Grounding the control ...................... 18
Customer connections for DC power and
ACvoltagesensing ....................... 20
The following are not functional for single-phase
AC voltage input: ......................... 20
Before placing the control and the
recloser into service ...................... 22
Using removable inserts .................... 28
ACCESSORIES .............................29
Discrete interface board (DIF) option accessory .. 29
Communication board accessories ............ 30
TESTING ..................................32
Testing an installed control .................. 32
Remove the control from service ............. 33
Electrical testing of triple-single reclosers: NOVA-TS
33
Return the control to service ................. 34
ADDITIONAL INFORMATION .................35
Replacement kits .......................... 35
Factory-authorized service centers ............ 35
Factory testing and troubleshooting classes ..... 35