Form 6 triple-single microprocessor-based rack mount recloser control
35INSTALLATION AND OPERATION INSTRUCTIONS MN280084EN July 2018
Additional information
CAUTION
This equipment requires routine inspection and
maintenance to ensure proper operation. If it is not
maintained, it can fail to operate properly. Improper
operation can cause equipment damage and possible
personal injury. G105.1
Replacement kits
Replacement kits for the Form 6 recloser control are
available through the factory Service Department. To
order these kits, refer to the Replacement Parts price
list for catalog numbers and pricing. Contact your Eaton
representative for additional information and
order procedures.
Factory-authorized service centers
Factory-authorized service centers are located throughout
the continental United States to provide maintenance,
repair and testing services for Eaton Cooper Power series
controls and reclosers. For further information, contact your
Eaton representative.
Factory testing and troubleshooting classes
The factory service department offers a basic testing and
troubleshooting course for the Form 6 microprocessor-based
electronic recloser control. This course, taught by
experienced service technicians, is held at the factory’s
in-house training facility. For additional information, contact
your Eaton representative.
To Next Page
Loading...
