Eaton Cooper Power Form 6-TS - Testing Procedures; Testing an Installed Control

Form 6 triple-single microprocessor-based rack mount recloser control
28 INSTALLATION AND OPERATION INSTRUCTIONS MN280084EN July 2018
Using removable inserts
NOTICE
Control damage. De-energize both AC and DC power
prior to removing or installing any internal connections
or circuit boards in the control. Failure to comply can
result in damage to the control. T241.1
NOTICE
Equipment damage. Always wear a grounding wrist
strap to control static electricity before handling circuit
boards. Failure to use this strap may result in circuit
board damage. T253.1
The front panel inserts can be changed, if desired.
1. De-energize both AC and DC power.
2. Use a flathead or 3/33” hex key screwdriver to unscrew
the six front panel screws.
3. Pull the right side of the front panel out towards the
left(Figure20).
ote:N Various connecting wires will keep the panel attached
to the control.
ote:N It is not necessary to disconnect any wires.
Removable LED
Status Indicator Panel
Figure20. Open front panel. Labels are easily removed
from and inserted into the top of the programming
panel LED status indicator section
4. Use tweezers to gently pull out the removable insert.
ote:N The insert will slide out of the right side of the
operating panel (Figure20).
ote:N The insert will slide out of the top of the
programming panel indicator section (Figure21).
5. Change the existing label or slide in a new label with
the name of the configured option.
An electronic label template is included on the ProView
application software CD and can be accessed through
the following default address:
C:\Program Files\Cooper\ProviewXX\Form 6\Form6
Inserts.doc
IMPORTANT
Laminate the removable inserts prior to installing. Thiswill
seal the ink/toner and avoid damage to the front panel.
6. Gently push the removable insert from right to left
into the right side of the operating panel (Figure21)
ordown into the programming panel LED indicator
section (Figure20).
Figure21. Labels are easily removed from and inserted
into the operating panel
7. Place the front cover panel back onto the control.
Using a flathead screwdriver screw the screws into the
control and tighten all hardware completely.