Eaton Cutler-Hammer DSII Series - 4-5.6 Spring Discharge Interlock; 4-5.7 Connected Breaker Manual Close Interlock; 4-5.8 Electric Lockout Equipped Breaker; 4-5.9 Closed Breaker Interlock

Page 30
l.B. 694C694-02
a. Breaker Open Springs
Discharged
c. Breaker Closed Springs
Charged
b. Breaker Closed Springs
Discharged
/
Trip Latch Held
Trip Latch Released
CD Stop Roller
@Close Cam
@ Roller Constraining Link
@Pivot Pin
@Trip Latch
@ Trip Shaft Latching Surface
(j) Trip Shaft
@Pole Shaft
@ Center Pole Lever
@ Pole Lever Pin
@ Moving Contact Arm
@ Stationary Arcing Contact
@ Moving Contact Pivot Pin
@ Main Drive Link
@Main Roller
@ Spring Release Latch
@ Insulating Link Adjusting
Stud and Locknut
@ Insulating Link
@ Mechanism Side Frame
@ Hardened Latch Surfaces
e. Trip Shaft Latch Details
a. Breaker Open - Springs Charged (Spring Charged Position
Corresponding to this Closing Cam Position Shown in Fig. 4-2).
Figure 4-7 Four Basic Positions of Breaker and Linkage (Enlarged View of Trip Shaft)
Effective 07 /97
Courtesy of NationalSwitchgear.com